If you are setting up a single pole configuration, the Wall Switch pairs directly to the Wi-Fi® network. For setting up a single pole Wall Switch, please skip to the “Primary Wall Switch Wi-Fi Pairing” section below.
In a 3- or 4-way configuration, the Wall Switches must first pair to each other using Bluetooth, followed by the Wi-Fi network pairing process. Begin with the “3- and 4-way Bluetooth Pairing” steps immediately below, then continue on to the Wi-Fi pairing process.
3- and 4-way Bluetooth Pairing:
1. Ensure power/breaker is turned back ON and the LEDs on all Wall Switches are solid purple.
2. Locate the primary Wall Switch. Hold 6 until the LED rapidly flashes blue (3 seconds) then release. Then, tap 1 to enter pairing mode. The LED will slowly flash blue.
3. Next, locate the secondary Wall Switch and repeat the steps above by holding 6 until the LED rapidly flashes blue (3 seconds) then release. Next tap 1 to begin the pairing mode. The LED will slowly flash blue.
The secondary Wall Switch will search and pair to the primary Wall Switch. The LED on each Wall Switch will rapidly blink green 5 times and each Wall Switch will beep 5 times to indicate the pairing process is complete.
For a 4-way configuration, repeat the steps above again, starting with step 2, to pair the primary Wall Switch to the remaining secondary Wall Switch.
Primary Wall Switch Wi-Fi Pairing:
1. On the primary Wall Switch press and hold 6 for 3 seconds and release when the LED rapidly flashes blue. Next Tap 2 to begin the Wi-Fi connection process.
2. Launch the iDevices Connected app and you will be guided through the process of connecting to the network. For iOS devices, you will need the HomeKit™ setup code on the pull-out tab of your primary Wall Switch.
Note: When opening the iDevices Connected app for the first time, several prompts will appear on the screen. Allow these prompts to ensure Apple’s HomeKit Protocol connects properly. If you didn’t allow one of the prompts, please go to your iOS Settings > iDevices to be sure that everything is turned ON.
Note: If Home Data or Synchronize Custom Home were OFF, go to Settings > Wi-Fi and toggle your Wi-Fi OFF and then back ON, before setting up your product.
Before pairing the iDevices Dimmer Switch to your Wi-Fi® network, ensure that your connected to a 2.4 GHz network. Click Here for for information.
Setting up your Wall Switch:
1. Available devices will be shown at the top of the app.
2. Your product will connect to the Wi-Fi network your iOS device is connected to.
3. The LED on the product will turn solid blue to indicate it has successfully joined your Wi-Fi network.
4. To ensure the app is adding the correct product, it will ask you to confirm its identity. The LED on the Wall Switch will blink purple to indicate it's the new product being added.
5. If this is your first HomeKit product, you'll be prompted to create your home and your first room.
6. When prompted, enter the 8-digit pin noted on the side of the Wall Switch or on the pull-out tab.
7. The app will now walk you through setting up your iDevices Wall Switch. Select a name for your product.
8. Select a name for how Siri® recognizes the LED nightlight on the product.
9. Choose a photo for the product. You can use the default photo or take a custom photo.
10. Choose the room your product is located in or create a new room.
11. Your iDevices Wall Switch is now setup!