1- Turn On/Increase Brightness
- Single tap to turn on. Press and hold to increase brightness level. Double tap to quickly increase light to maximum brightness.
- Note: Dimmable feature only available when paired to a dimmable iDevices product.
2- Turn Off/Decrease Brightness
- Single tap to turn off. Press and hold to decrease brightness level. Double tap to quickly decrease light to minimum brightness level.
- Note: Dimmable feature only available when paired to a dimmable iDevices product
3- Status LED
- Provides setup status.
4- 3M Command™ Strip Access Door
- Remove to access 3M Command™ Strip when removing Instant Switch from wall.
- Built-in level ensures precise installation.
6- Instant Switch Unit Removal
- Press sides to remove Instant Switch from mounting plate to access battery.
7- Pairing Reset
- Press and hold for 10 seconds, until LED blinks red.
7 + 1- Device Reset:
- Press and hold 7+1 simultaneously for 10 seconds, then release to cycle power to the device.
8- Ground Wire Assembly
- Connect to Instant Switch when installing into a gang box.